Requirement (firmware update)
You can find the latest firmware for SIMOTION D:
●
On the SIMOTION SCOUT DVDs (e.g. at …\3_D410_2\Firmware\V4.3.1.4)
● On the Internet at Internet address (
http://support.automation.siemens.com/WW/view/en/
31045047)
Upgrading the SIMOTION D410‑2 automatically upgrades the firmware of all connected
SINAMICS DRIVE-CLiQ components.
Note
Observe the information in the the Read Me files and the upgrade instructions included in the
scope of delivery of new SIMOTION versions.
Use only CF cards that have been approved for use with the SIMOTION D410‑2 and whose
boot loader version is correct.
You can find the compatibility relationships in the SIMOTION SCOUT Add‑Ons "software
products" compatibility list, as well as at Internet address (http://
support.automation.siemens.com/WW/view/en/18857317).
NOTICE
The upgrade operation deletes all project data and parameters from the CF card!
Back up the data before starting an upgrade.
Requirement (project update)
You
have updated your project and, if necessary, adapted the device type and device version.
See Section Customizing the project (Page 269).
8.4.3 Update via SIMOTION IT web server
SIMOTION D410-2 has an integrated web server.
In addition to customized web pages and comprehensive device/diagnostic information,
SIMOTION IT web server also allows you to update the firmware and project using a standard
PC with a web browser.
You will find detailed information in the
SIMOTION IT Diagnostics and Configuration
Diagnostics Manual.
Service and maintenance
8.4 Performing a firmware and project update
SIMOTION D410-2
282 Commissioning and Hardware Installation Manual, 01/2015
To Next Page
Loading...
Need help?
General
