Siemens SIMOTION D410-2 DP User Manual

Procedure
To upgrade a SINAMICS drive unit, proceed as follows:
1.
Right-click the relevant device, e.g. the SINAMICS S120 CU310‑2 DP.
2. Select "Target device" > "Upgrade Device Version/Characteristic" in the context menu.
The "Upgrade Device Version/Characteristic" dialog box is displayed. It lists all available
firmware versions.
Figure 8-8 Upgrading the device version
3.
Select the desired device version/characteristic and click "Upgrade".
This upgrades the SINAMICS S120 Control Unit.
8.3.10 Upgrade the libraries
Depending on the configured properties of the libraries used in the project (device-dependent
or device-independent), an upgrade of the libraries may be required if the SIMOTION device
or the device version changes.
1. Open the LIBRARIES directory in the project navigator.
2. Select a library, right-click to open the context menu, and select "Properties...."
3. Select the "TPs/TOs" tab in the "Properties" window.
4. Select the SIMOTION device and the technology packages for which the library is to be
valid.
5. Close the dialog box with "OK".
Note
Please also observe the notes on device-dependencies in the SIMOTION SCOUT online
help.
Service and maintenance
8.3 Customizing the project
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015 279

Siemens SIMOTION D410-2 DP Specifications

General

Brand	Siemens
Model	SIMOTION D410-2 DP
Category	Controller
Language	English