Siemens SIMOTION D410-2 DP User Manual

7.15 Loading and saving SIMOTION user data
Overview
After
commissioning the SIMOTION D410-2, we recommend that you back up the SIMOTION
user data (programs, configuration data and parameter assignments) on the CF card.
Loading user data
Use the "Target system" > "Load" > "Load to target system" command to transfer the following
data from the SIMOTION SCOUT engineering system (ES) to the "non-volatile SIMOTION
data" area of SIMOTION D410-2:
● Configuration data
● Programs
● Parameterization
● Technology packages
The hardware configuration of the SIMOTION D410-2 and the retain variables are also stored
in the "non-volatile SIMOTION data" area.
Note
Using the menu:
●
"Target system" > "Load" > "Load project to target system" loads all of the project data to
the target system.
● "Target system" > "Load" > "Load CPU / drive unit to target device" only loads the data of
the selected device / drive element to the target device.
After the SIMOTION D410-2 is switched off, the contents of the "volatile SIMOTION data" area
are lost.
Additional references
Additional information about the SIMOTION SCOUT engineering system can be found in the
SIMOTION SCOUT Configuration Manual.
Commissioning (software)
7.15 Loading and saving SIMOTION user data
SIMOTION D410-2
Commissioning and Hardware Installation Manual, 01/2015 231

Siemens SIMOTION D410-2 DP Specifications

General

Brand	Siemens
Model	SIMOTION D410-2 DP
Category	Controller
Language	English