Siemens SINUMERIK 808D Parameter Manual

10704 DRYRUN_MASK N01 V1
- Dry run feedrate activation BYTE PowerOn
-
- - 0 0 2 1/1 M
Description: DRYRUN_MASK == 0
Dryrun can only be switched on or off at the end of the block.
When DRYRUN_MASK = 1 is set, the dry run feedrate can also be activated during program
execution (in the part program block).
NOTICE!
After activating dry run feedrate, the axes are stopped for the duration of the
reorganization process.
DRYRUN_MASK == 2
Dryrun can be switched on or off in every phase and the axes are not stopped.
NOTICE:
However, the function does not become active until a "later" block in the program
execution and this is with the next (implicit) StopRe block.
Related to:
SD42100 $SC_DRY_RUN_FEED
10706 SLASH_MASK N01 PG, A2
- Activation of block skip BYTE PowerOn
-
- - 0 0 2 1/1 M
Description: If SLASH_MASK = 0, skip block can only be activated when stopped at the end of the block
If SLASH_MASK = 1, skip block can also be activated during program execution.
NOTICE!
After activating skip block, the axes are stopped for the duration of the
reorganization process.
If SLASH_MASK = 2 ,skip block can be activated in every phase.
Notice!
However, the function does not become active until a "later" block in the program
execution, and this is with the next (implicit) StopRe block.
10707 PROG_TEST_MASK N01 K1
- Program test mode DWORD PowerOn
-
808d-me42 - 0x1 0 0x1B 1/1 M
808d-me62 - 0x1 0 0x1B 1/1 M
808d-te42 - 0x1 0 0x1B 1/1 M
808d-te62 - 0x1 0 0x1B 1/1 M
808d-mte40 - 0x11 0 0x1F 1/1 M
808d-mte60 - 0x11 0 0x1F 1/1 M
Description: Bit-coded mask for program test
Bit 0 == 1 Program test cannot be deselected in 'Stopped' program status.
Bit 1 == 1 Enable to activate the program test using the PI command _N_NCKMOD
Bit 2 == 1 Activation of program test with accelerated feed in normal program
processing. If the bit is set, the program test is active in all channels with
accelerated
feed via
the VDI signal in the first channel. The VDI signal has no effect
in all other channels as long as the bit is set. The value in $MC_SERUPRO_SPEED_FACTOR
of the first channel is used as the feed. Only released for test purposes.
Machine data
3.2 General machine data
Parameter Manual
List Manual, 01/2017 43

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English