SINAMICS parameters
7
7.1 SINAMICS V70 parameters
This section lists only the parameters displayed on the drive BOP and those frequently used
for drive commissioning. For more parameters of the servo drive, see SINUMERIK 808D
ADVANCED HMI through the following operations:
+ → → →
All parameters beginning with "p" are editable parameters, for example, p29000.
All parameters beginning with "r" are read-only parameters, for example, r0018.
Effective
Indicates the conditions for making parameterization effective. Two conditions are possible:
●
IM (
Immediately): Parameter value becomes effective immediately after changing.
●
RE (Reset): Parameter value becomes effective after repower-on.
Can be changed
Indicates the state in which a parameter is changeable. Two states are possible:
● U (Run): Can be changed in the "Running" state when the enable signal is available. The
"RDY" LED indicator lights up green.
● T (Ready to run): Can be changed in the "Ready" state when the enable signal is missing.
The "RDY" LED indicator lights up red.
Note
When judging the
state of the drive according to the "RDY" LED indicator, ensure that no faults
or alarms exist.
Data type
Type Description
I16 16-bit integer
I32 32-bit integer
U16 16 bits without sign
U32 32 bits without sign
Uint16 16-bit unsigned integer
Parameter Manual
List Manual, 01/2017 509
To Next Page
Loading...
Need help?
General
