1004 Axis 2 in Work
Traversing keys Rapid tra‐
vers over‐
ride
Traversing
key disable
Feedrate
stop
Activate handwheel (bit/binary coded)
Plus Minus 2 1
1005 Axis 2 in Work
Machine function
2)
Continuous
traversing
Var. INC 10000 INC 1000 INC 100 INC 10 INC 1 INC
1006
1007
Invert hand‐
wheel
direc‐
tion
1008 Axis 3 in Work
Traversing keys Rapid tra‐
verse over‐
ride
Traversing
key disable
Feedrate
stop
Activate handwheel (bit/binary coded)
Plus Minus 2 1
1009 Axis 3 in Work
Machine function
2)
Continuous
traversing
Var. INC 10000 INC 1000 INC 100 INC 10 INC 1 INC
1010
1011 Invert hand‐
wheel
direc‐
tion
1)
The handwheel number
is represented according to the $MD_HANDWH_VDI_REPRESENTATION machine data in a bit-
coded (=0) or binary-coded (=1) manner.
2)
Machine function: the machine function is only entered if the "INC inputs in the operating-mode signal range active" signal
(DB2600.DBX1.0) is not set.
6.10.2 Signals from NC channel
Status signals from NC channel
DB3300 Signals from NCK channel [r]
NCK → PLC interface
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Last action
block active
M0/M1 ac‐
tive
Approach
block active
Action
block active
Forwards
traverse ac‐
tive
Backwards
traverse ac‐
tive
Execution
from exter‐
nal active
1 program
test active
M2/M30 ac‐
tive
Block
search ac‐
tive
Handwheel
override ac‐
tive
Rev. feder‐
ate active
Referenc‐
ing active
2
PLC user interface
6.10 Channel signals
Parameter Manual
492 List Manual, 01/2017
To Next Page
Loading...
Need help?
General
