For more information about the embedding of the functions in the device, please refer to chapter 2.1 Function
Embedding in the Device.
The entire function scope of the application templates can be found in chapter 4.2 Application Template and
Functional Scope for the Fault Recorder .
Structure of the Function Group
The function group Voltage-current 3-phase always contains the function block General that cannot be
deleted.
You can load the trigger functions required for your application in the function group. These trigger functions
are available from the Global DIGSI 5 library. Trigger functions that are not needed can be deleted again from
the function group.
The following figure shows the structure of the function group Voltage-current 3-phase.
[dwfgspst-240812-01.tif, 4, en_US]
Figure 6-8
Structure of the Voltage-Current 3-Phase Function Group
The function group has interfaces to the voltage and current measuring points.
The recorder routings enable the routing of the individual measured values to the various recorders. The
following figure shows the structure of the Recorder routing VI function group.
6.3.2
Function-Group Types
6.3 Function-Group Type Voltage/current 3-Phase
146 SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
To Next Page
Loading...
Need help?
General
