Siemens SIPROTEC 5 User Manual

Addr. Parameter C Setting Options Default Setting
_:9691:112 Trigger V2 1:Filter time 2 cycles to 250 cycles 2 cycles
Information List
No. Information Data Class
(Type)
Type
Trig. V fund 1
_:9571:54 Trig. V fund 1:Inactive SPS O
_:9571:52 Trig. V fund 1:Behavior ENS O
_:9571:53 Trig. V fund 1:Health ENS O
_:9571:301 Trig. V fund 1:Trigger active SPS O
Trig. V RMS 1
_:9601:54 Trig. V RMS 1:Inactive SPS O
_:9601:52 Trig. V RMS 1:Behavior ENS O
_:9601:53 Trig. V RMS 1:Health ENS O
_:9601:301 Trig. V RMS 1:Trigger active SPS O
Trigger V0 1
_:9631:54 Trigger V0 1:Inactive SPS O
_:9631:52 Trigger V0 1:Behavior ENS O
_:9631:53 Trigger V0 1:Health ENS O
_:9631:301 Trigger V0 1:Trigger active SPS O
Trigger V1 1
_:9661:54 Trigger V1 1:Inactive SPS O
_:9661:52 Trigger V1 1:Behavior ENS O
_:9661:53 Trigger V1 1:Health ENS O
_:9661:301 Trigger V1 1:Trigger active SPS O
Trigger V2 1
_:9691:54 Trigger V2 1:Inactive SPS O
_:9691:52 Trigger V2 1:Behavior ENS O
_:9691:53 Trigger V2 1:Health ENS O
_:9691:301 Trigger V2 1:Trigger active SPS O
Current Trigger
Overview of Functions
Current triggers start with exceeding or dropping below the set limiting values (level and gradient trigger) in
the fast-scan and slow-scan recorders. It is triggered by fundamental values, RMS values, or on symmetrical
components.
Structure of the Function
The Current trigger function can be configured in the 3-phase voltage / current function group.. The struc-
ture of the function Current trigger is shown in the following figure:
7.5.1.10
7.5.2
7.5.2.1
7.5.2.2
Fault Recorder
7.5 Trigger Functions 3-Phase
312 SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017

Siemens SIPROTEC 5 Specifications

General

Brand	Siemens
Model	SIPROTEC 5
Category	Controller
Language	English