Suzuki Swift User Manual

6-92 ENGINE GENERAL INFORMATION AND DIAGNOSIS (TBI FOR G10)
Fig. 1 for Step 1
DTC P1450 BAROMETRIC PRESSURE SENSOR LOW/HIGH INPUT
DTC P1451 BAROMETRIC PRESSURE SENSOR PERFORMANCE PROBLEM
WIRING DIAGRAM/CIRCUIT DESCRIPTION
Barometric pressure sensor is installed in ECM (PCM).
DTC DETECTING CONDITION
POSSIBLE CAUSE
DTC P1450:
D Barometric pressure: 136 kPa 1025 mmHg or higher, or
33 kPa 250 mmHg or lower
D ECM (PCM) (barometric pressure sensor)
malfunction
DTC P1451:
D Vehicle stopped.
D Engine cranking.
D Difference between barometric pressure and intake
manifold absolute pressure is 26 kPa, 200 mmHg or more.
: 2 driving cycle detection logic, monitoring once/1 driving.
D Manifold absolute pressure sensor and its
circuit malfunction
D ECM (PCM) (barometric pressure sensor)
malfunction
DTC CONFIRMATION PROCEDURE
1) Turn ignition switch OFF.
2) Clear DTC with ignition switch ON.
3) Turn ignition switch ON for 2 sec., crank engine for 2 sec. and run it at idle for 1 min.
4) Check pending DTC in “ON BOARD TEST” or “PENDING DTC” mode and DTC in “DTC” mode.
INSPECTION
DTC P1450:
Substitute a known-good ECM (PCM) and recheck.
DTC P1451:
NOTE:
Note that atmospheric pressure varies depending on weather conditions as well as altitude.
Take that into consideration when performing these check.
STEP
ACTION YES NO
1 1) Connect scan tool to DLC with ignition switch
OFF.
2) Turn ignition switch ON and select “DATA
LIST” mode on scan tool.
3) Check manifold absolute pressure. See Fig. 1.
Is it barometric pressure (approx. 100 kPa,
760 mmHg) at sea level?
Substitute a known-
good ECM (PCM) and
recheck.
Check intake manifold
pressure sensor and its
circuit.
Go to P0105 DIAG.
FLOW TABLE.

Suzuki Swift Specifications

General

Brand	Suzuki
Model	Swift
Category	Automobile
Language	English