To Next Page

To Previous Page

8G-14 IMMOBILIZER CONTROL SYSTEM

1. Main fuse

2. Main relay

3. ECM

4. Immobilizer indicator lamp

(Vehicle not equipped with

monitor coupler)

For G10 engine

For G13B engine

For G10 engine For G13B engine

A-2 IMMOBILIZER INDICATOR LAMP CHECK

(IMMOBILIZER INDICATOR LAMP DOSE NOT LIGHT AT IGNITION SWITCH ON)

STEP ACTION YES NO

1 1) Turn ignition switch ON.

Do other indicator/warning lights in

combination meter come ON?

Go to Step 2. “IG” fuse blown, main fuse blown,

ignition switch malfunction,

“(d)” circuit between “IG” fuse

and combination meter or poor

coupler connection at

combination meter.

2 1) Turn ignition switch OFF and

disconnect connectors from ECM.

2) Check for proper connection to ECM

at terminal C02-18 for G10 engine or

C01-28 for G13B engine.

3) If OK, then using service wire, ground

terminal C02-18 for G10 engine or

C01-28 for G13B engine in connector

disconnected.

Does immobilizer indicator lamp turn on

at ignition switch ON?

Substitute a known-

good ECM and

recheck.

Bulb burned out or “(P)” wire

circuit open.

Suzuki Swift User Manual

Other manuals for Suzuki Swift