To Next Page

To Previous Page

1. Rotor plate

2. Inner rotor:

Apply thin coat of engine oil.

3. Outer rotor:

Apply thin coat of engine oil.

4. Gasket

5. Pin

6. Pin

7. Relief valve:

Apply thin coat of engine oil.

8. Spring

9. Retainer

10. Retainer ring

11. Front oil seal:

Apply engine oil to contact

part of crankshaft with oil seal lip.

12. Plate screw

13. Bolt (short)

14. Bolt (long)

: Tightening Torque

: Do not reuse

6A1-28 ENGINE MECHANICAL (G13B, 1-CAM 16-VALVES ENGINE)

OIL PUMP

REMOVAL

1) Disconnect negative cable at battery.

2) Remove timing belt as previously outlined.

3) Remove generator and its bracket.

NOTE:

When installing bracket, fasten nut (A) first.

4) Remove power steering pump bracket or A/C compressor

bracket, if equipped.

NOTE:

When installing bracket, fasten bolt (B) first.

5) Remove oil pan and oil pump strainer as previously outlined.

6) Remove crankshaft timing belt pulley (3).

Lock crankshaft inserting flat end rod or the like (1) between fly-

wheel ring gear and transmission case.

With crankshaft locked, remove crankshaft timing belt pulley

bolt (2).

Suzuki Swift User Manual

Other manuals for Suzuki Swift