Xerox 4590/4110 Copier/Printer User Guide
2-89
2. Copy
Separators Tray
Select tray for separator.
When Bypass is selected, the Tray 5 (Bypass) screen appears.
Refer to “Tray 5 (Bypass) Screen” on page 2-21.
Quantity
The number of separators can be set from 1 to 99 when selecting
Blank Separators. Only this feature is available, when Blank
Separators is selected.
Copy Screen
Stop
The document data stored by the Build Job feature is cleared and
the build job is canceled.
NOTE: The same operation is performed if you press the C button
or Clear All button on the Control Panel.
Stop is displayed while you scan documents. By pressing
Stop, you can cancel the scanning documents. Pressing
either Start on the touch screen or the Start button on the
Control Panel restart to scan documents.
Last Original
Select this to end scanning of documents. The build job starts.
Next Original
Select this when you have another document. When using Build
Job feature, this item has been selected.
Start
You can load the next document and configure the settings for the
document.
NOTE: The same operation is performed if you press the Start
button on the Control Panel.
Change Settings
The Copy screen appears and you can change the settings for the
loaded document. After setting the features, press the Start button
on the Control Panel to start scanning of the document.
To Next Page
Loading...
Need help?
General