Xerox 4590/4110 Copier/Printer User Guide
10-18
10. Maintenance
3. Discard all the punch scraps in an appropriate container.
4. Insert the empty punch scrap container as far as possible.
CAUTION: Pulling out the container and pushing it back into
place resets the punch counter setting to 0. Make sure to
completely empty the container so the counter number accurately
matches the state of the container.
5. Close the right cover of the light finisher.
NOTE: A message will be displayed and the machine will not
operate if the right cover is even slightly open.
Cleaning the Machine
The following section describes how to clean the machine.
This section is divided into separate descriptions on how to clean
the exterior, internal components, document cover/document
feeder, and document glass.
Cleaning the Exterior
The following procedure describes how to clean the exterior.
KEY POINT: Before you start to clean the machine, be sure to
switch off and unplug the machine. Cleaning the machine without
switching off the power may cause an electric shock.
Do not use benzene, paint thinner, other volatile liquids, or
spray insect repellent on the machine as doing so may
discolor, deform, or crack covers.
To Next Page
Loading...
Need help?
General