Xerox 4590/4110 Copier/Printer User Guide
3-45
3. Scan
Variable Erase
You can erase only the amount necessary.
• Top & Bottom
Shadows at the top and bottom of the document are
erased. Edges on the top and bottom are erased with
respect to the direction that the document was loaded. The
border erase width can be set within the range 0 to 1.97
inches (0 to 50 mm) in .05 inch (1 mm) increments.
• Left & Right
Shadows on the left and right of the document are erased.
Edges on the left and right are erased with respect to the
direction that the document was loaded. The border erase
width can be set within the range 0 to 1.97 inches (0 to 50
mm) in .05 inch (1 mm) increments.
• Center
Shadows in the center of documents such as booklets or
documents with facing pages are erased. The center erase
width can be set within the range 0 to 1.97 inches (0 to 50
mm) in .05 inch (1 mm) increments.
Top/Bottom Edges
Shadows at the top and bottom of the document are erased.
Edges on the top and bottom are erased with respect to the
direction that the document was loaded. The border erase width
can be set within the range 0 to 50 mm in 1 mm increments.
Left/Right Edges
Shadows on the left and right of the document are erased. Edges
on the left and right are erased with respect to the direction that
the document was loaded. The border erase width can be set
within the range 0 to 50 mm in 1 mm increments.
Center Erase
Shadows in the center of documents such as booklets or
documents with facing pages are erased. The center erase width
can be set within the range 0 to 50 mm in 1 mm increments.
Original Orientation
In order to identify the top of the document, the orientation of the
set document must be configured.
For more information, refer to “Originals Orientation” on page 3-
31.
To Next Page
Loading...
Need help?
General