04/2016
4-136
Phaser 4600/4620/4622 Printer Service Manual
REP 12.7, REP 12.8
Revised
4 Repairs and Adjustments
Figure 1 Remove the exit gate actuator
REP 12.8 Finisher Entrance Drive Belt
Parts List on PL 12.40 Item 16
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Separate the Finisher from the printer, GP 14.
2. Remove the left cover, REP 12.1.
3. Remove the exit gate actuator, REP 12.7.
4. Remove but do not disconnect the Exit Gate Sensor, REP 12.6.
5. Compress the spring and remove the E-clip that secures the outer bearing in the bracket,
Figure 1.
Figure 1 Release the bearing from the bracket
6. Move the shaft outwards to release the shaft from the Finisher, then tilt the shaft up to
remove, Figure 2.
To Next Page
Loading...
Need help?
General