04/2016
4-148
Phaser 4600/4620/4622 Printer Service Manual
REP 12.24
Revised
4 Repairs and Adjustments
REP 12.24 Stacker Shield Assembly
Parts List on PL 12.20 Item 1
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Separate the Finisher from the printer, GP 14.
2. Remove the right cover, REP 12.11.
3. Remove the left cover, REP 12.1.
4. Retract the eject assembly into the Finisher.
5. Remove 4 screws (plastic) that secure the assembly to the Control Board bracket and
Finisher chassis, Figure 1.
Figure 1 Remove 4 screws of the left side
6. Remove 3 screws (1 metal, 2 plastic) that secure the Stapler Assembly to the Finisher,
Figure 2.
Figure 2 Remove, but do not disconnect the Stapler Assembly
7. Remove 3 screws (plastic) that secure the Stacker Shield Assembly to the Finisher, Fig-
ure 3.
To Next Page
Loading...
Need help?
General