ABB PST72 Installation And Commissioning Manual

Settings and configuration
Chapter 7
102
1SFC132003M0201
7:2.4.5 Faults
Caution!
The motor may start unexpectedly if there is a start signal
present when the softstarter has tripped for a fault and a
reset is performed. This reset can be either manual (Stop-
M) or automatic (Stop-A).
Phase loss fault, type of operation (Ph Loss
Op)
Select what operation shall be asserted if a phase loss fault
occurs:
Stop–M The motor will stop and a manual reset is
required.
Stop–A The motor will stop and an automatic reset is
performed.
Press Store to save the selected operation.
Fieldbus fault, type of operation (FB Fault Op)
Select what operation shall be asserted if a fieldbus
communication fault occurs:
Stop–M The motor will stop and a manual reset is
required.
Stop–A The motor will stop and an automatic reset is
performed.
Press Store to save the selected operation.
Frequency fault, type of operation (Freq F Op)
Select what operation shall be asserted if the frequency fault
occurs (out of range):
Stop–M The motor will stop and a manual reset is
required.
Stop–A The motor will stop and an automatic reset is
performed.
Press Store to save the selected operation.
Heat sink over-temperature fault, type of
operation (HS Temp Op)
Select what operation shall be asserted if an over-
temperature occurs:
Stop–M The motor will stop and a manual reset is
required.
Start/Stop
Protections
Warnings
Inputs
Faults
Outputs
Fieldbus
F
igure 30: Faults group
Seq Start
Settings
Functional Settings
Torque control
Analog Output

ABB PST72 Specifications

General

Brand	ABB
Model	PST72
Category	Controller
Language	English