ABB PST72 Installation And Commissioning Manual

Settings and configuration
Chapter 7
117
1SFC132003M0201
7:2.7.1 Changed Settings
The Changed settings menu consists of the parameters that
have been changed in contrast to the factory default setting.
If no parameters have been changed, the LCD will display No
Changed Settings.
7:2.7.2 Reset all Settings
To reset all the changed parameters back to factory default
setting, enter this menu.
Confirmation of reset will be displayed as Done on the LCD.
The supply voltage should also be disconnected and
reconnected.
The real time clock, the hour run meter, the number of starts
and the presentation language will not be affected by the
reset.
Caution!
The motor may start unexpectedly if there is a start signal
present when doing any of the actions listed below.
• Switching from one type of control to another (fieldbus
control / hardwire control)
• Re-programming of the programmable inputs
• Reset all Settings (programmable input set to Enable)
Application
Settings
Basic
Settings
Functional
Settings
Service
Settings
Presentation
Settings
All
Settings
Changed
Settings
Reset all
Settings
Figure 39: Changed Settings menu
Top Level
Settings
Operation
Mode
Application
Settings
Basic
Settings
Functional
Settings
Service
Settings
Presentation
Settings
All
Settings
Changed
Settings
Reset all
Settings
F
igure 40: Reset all Settings menu
Top Level
Settings
Operation
Mode

ABB PST72 Specifications

General

Brand	ABB
Model	PST72
Category	Controller
Language	English