AMX DGX3200-ENC User Manual

Product Overview and General Specifications
27
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
NetLinx NX Master Telnet Commands
The table below contains Telnet commands which apply to the integrated NetLinx NX Master.
NOTE: For further information about using Telnet commands and a complete list of commands available for NetLinx NX Central
Controllers, see the “WebConsole & Programming Guide – NX-Series Controllers” at www.amx.com.
NetLinx NX Telnet Commands for the Integrated NetLinx NX Master
Command Description
AUTO LOCATE (ENABLE|DISABLE|STATUS) Enables/disables/queries the auto locate feature on the integrated Master. Auto
locate adds additional broadcast information for use by AMX Touch Panel devices
configured in Auto connect mode.
Syntax:
Auto Locate [enable|disable|status]
DOT1X (ENABLE|DISABLE|STATUS) Enables/disables 802.1x security or displays its current settings. The default
settings is disable.
Syntax:
DOT1X[status|enable|disable]
MANAGE FIRMWARE Telnet interface to load previous and factory firmware versions for both the
integrated Master (device 0) and controller (device 5001).
Example:
>manage firmware
Devices
-------
0 - Master
5001
Select device or press return to cancel:0
Current Version: 1.2.259
Previous Version: 1.2.258
Factory Version: 1.2.250
To install a firmware version:
Enter P (Previous), F (Factory) or press return to cancel:
PROGRAM (ENABLE|DISABLE|STATUS) Enable/disable the NetLinx program or display the status of the current program
execution setting. The default setting is enable.
Important: For information on using this command, see page 60.
The setting (enable or disable) persists through power down and through
firmware updates, etc., until a new command is sent. If the software setting is
disabled, then the NetLinx program is disabled.
Syntax:
PROGRAM [status|enable|disable]
PROGRAM INFO Displays a list of program files and modules residing on the integrated Master.
Example:
>PROGRAM INFO
-- Program Name Info
-- Module Count = 1
1 Name is i!-PCLinkPowerPointTest
-- File Names = 2
1 = C:\Program Files\AMX Applications\i!-PCLinkPowerPoint
2 = C:\Program Files\Common Files\AMXShare\AXIs\NetLinx.axi
2 = Name is MDLPP
--File Names = 2
1 C:\AppDev\i!-PCLink-PowerPoint\i!-PCLinkPowerPointMod.axs
2 C:\Program files\Common Files\AMXShare\AXIs\NetLinx.axi
REBOOT Reboots the integrated Master or specified device. Options for rebooting the Master
are cold, soft, and warm. The reboot command with no parameter executes as
“reboot cold”.
Example (Rebooting device):
>REBOOT [0:1:0]
Rebooting...
Example (Rebooting Master):
>reboot cold
Reboots the Master and restarts the entire operating system.
>reboot warm
>reboot soft
Reboots the Master but only starts the AMX NetLinx application firmware.

AMX DGX3200-ENC Specifications

General

Brand	AMX
Model	DGX3200-ENC
Category	Switch
Language	English