AudioCodes MSBG Series User Manual

Version 7.2 1041 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
[MaxDigits]
these digits for the called destination number.
The valid range is 1 to 49. The default is 5 for analog and 30 for digital.
Note:
 Instead of using the parameter, Digit Mapping rules can be
configured.
 For FXS/FXO interfaces: Dialing ends when any of the following
scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed
 Digit map pattern is matched
Inter Digit Timeout for
Overlap Dialing
configure voip > gateway
dtmf-supp-service dtmf-and-
dialing > time-btwn-dial-digs
[TimeBetweenDigits]
Analog: Defines the time (in seconds) that the device waits between
digits that are dialed by the user.
ISDN overlap dialing: Defines the time (in seconds) that the device
waits between digits that are received from the PSTN or IP during
overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Enable Special Digits
configure voip > gateway
dtmf-supp-service dtmf-and-
dialing > special-digits
[IsSpecialDigits]
Determines whether the asterisk (*) and pound (#) digits can be used
in DTMF.
 [0] Disable = Use '*' or '#' to terminate number collection (refer to
the parameter UseDigitForSpecialDTMF). (Default.)
 [1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note:
 The symbols can always be used as the first digit of a dialed
number even if you disable the parameter.
 The parameter is applicable only to analog interfaces.
62.10.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Table 62-41: Voice Mail Parameters
Parameter Description
Voice Mail Interface
configure voip > gateway voice-mail-
setting > vm-interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines
the communication method between the device and PBX.
 [0] None (default)
 [1] DTMF
 [2] SMDI
 [3] QSIG
 [4] SETUP Only = Applicable only to ISDN.
 [5] MATRA/AASTRA QSIG
 [6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English