AudioCodes MSBG Series User Manual

Version 7.2 1061 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
The interworking of the received Setup message to a SIP
INVITE is suspended when the parameter is set to any value
greater than 0. This means that the redirecting number in the
Setup message is not checked. When a subsequent Facility
with Call Transfer Complete/Update is received with a non-
empty Redirection
Number, the Calling Number is replaced with
the received redirect number in the sent INVITE message.
If the timeout expires, the device sends the INVITE without
changing the calling number.
Note:
 The suspension of the INVITE message occurs for all calls.
 The parameter is applicable only to QSIG.
Call Transfer using re-INVITEs
configure voip > sip-definition
settings > enable-call-transfer-
using-reinvites
[EnableCallTransferUsingReinvites]
Enables call transfer using re-INVITEs.
 [0] Disable = (Default) Call transfer is done using REFER
messages.
 [1] Enable = Call transfer is done by sending re-INVITE
messages (instead of REFER).
Note:
 To support the feature, the device must be installed with an
MPM.
 The device uses two DSP channels per transferred call.
Thus, to use this feature, you also need to configure the
maximum number of available DSP channels, using the
MediaChannels parameter.
 The parameter is applicable only to FXS interfaces.
62.10.5.7 Multi-Line Extensions and Supplementary Services Parameters
The multi-line extensions and supplementary services parameters are described in the
table below.
Table 62-48: Multi-line Extensions and Supplementary Services Parameters
Parameter Description
Supplementary Services Table
Supplementary Services
Table
configure voip >
gateway digital isdn-
supp-serv
[ISDNSuppServ]
Defines phone extension numbers per FXS/BRI port and configures
various supplementary services per endpoint.
The format of the ini file table parameter is as follows:
[ ISDNSuppServ ]
FORMAT ISDNSuppServ_Index = ISDNSuppServ_PhoneNumber,
ISDNSuppServ_LocalPhoneNumber, ISDNSuppServ_Module,
ISDNSuppServ_Port, ISDNSuppServ_UserId,
ISDNSuppServ_UserPassword, ISDNSuppServ_CallerID,
ISDNSuppServ_IsPresentationRestricted,
ISDNSuppServ_IsCallerIDEnabled;
[ \ISDNSuppServ ]
For a detailed description of the table, see ''Configuring Multi-Line
Extensions and Supplementary Services'' on page 565.

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English