User's Manual 1184 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[CallSetupRules]
[ CallSetupRules ]
FORMAT CallSetupRules_Index = CallSetupRules_RulesSetID,
CallSetupRules_QueryType, CallSetupRules_QueryTarget,
CallSetupRules_AttributesToQuery, CallSetupRules_AttributesToGet,
CallSetupRules_RowRole, CallSetupRules_Condition,
CallSetupRules_ActionSubject, CallSetupRules_ActionType,
CallSetupRules_ActionValue;
[ \CallSetupRules ]
For a description of the table, see ''Configuring Call Setup Rules'' on
page 377.
62.13.4 HTTP-based Services
The HTTP-based service parameters are described in the table below.
Table 62-79: HTTP-based Service Parameters
Parameter Description
GW Routing Server
configure voip > gw routing
general-setting > gw-
routing-server
[GWRoutingServer]
Enables routing by a Routing server.
ï‚§ [0] Disable = (Default)
ï‚§ [1] Enable
For more information, see Centralized Third-Party Routing Server on
page 269.
Note: The parameter is applicable only to the Gateway application.
Topology Status
configure system >
http-services >
routing-server-
group-status
[RoutingServerGroupStatus]
Enables the reporting of the device's topology status (using the REST
TopologyStatus API command) to HTTP remote hosts.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
For more information, see ''Configuring HTTP Services'' on page 262.
Remote Web Services Table
Remote Web Services
configure system > http-
services > http-remote-
services
[HTTPRemoteServices]
Defines remote Web services.
The format of the ini file table parameter is as follows:
[HTTPRemoteServices]
FORMAT HTTPRemoteServices_Index =
HTTPRemoteServices_Name, HTTPRemoteServices_Path,
HTTPRemoteServices_HTTPType, HTTPRemoteServices_Policy,
HTTPRemoteServices_LoginNeeded,
HTTPRemoteServices_PersistentConnection,
HTTPRemoteServices_NumOfSockets,
HTTPRemoteServices_AuthUserName,
HTTPRemoteServices_AuthPassword,
HTTPRemoteServices_TLSContext,
HTTPRemoteServices_VerifyCertificate,
HTTPRemoteServices_TimeOut,
HTTPRemoteServices_KeepAliveTimeOut,
HTTPRemoteServices_ServiceStatus;
[\HTTPRemoteServices]
For a description of the table, see ''Configuring Remote Web Services''