Version 7.2 1047 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
[DigitPatternDigitToIgnore]
62.10.5 Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
62.10.5.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Table 62-42: Caller ID Parameters
Parameter Description
Caller ID Permissions Table
Caller ID Permissions
configure voip > gateway dtmf-
supp-service supp-service-
> enable-caller-id
[EnableCallerID]
This table parameter enables (per port) Caller ID generation
(FXS interfaces) and detection (FXO interfaces).
The format of the ini file table parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Module, EnableCallerID_Port;
[\EnableCallerID]
Where,
 Module = Module number, where 1 denotes the module in
Slot 1.
 Port = Port number, where 1 denotes Port 1 of a module.
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of Module
3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of Module
3)
For a detailed description of the table, see Configuring Caller ID
Permissions on page 586.
Note:
 The indexing of the parameter starts at 0.
 The parameter is applicable only to analog interfaces.
Caller Display Information Table
Caller Display Information
configure voip > gateway analog
caller-display-info
[CallerDisplayInfo]
This table parameter enables the device to send Caller ID
information to the IP side when a call is made. The called party
can use this information for caller identification. The information
configured in this table is sent in the SIP INVITE message's
From header.
The format of the ini file table parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
To Next Page
Loading...
Need help?
General
