User's Manual 278 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
resolution results in multiple IP addresses, the device uses the
first available address (i.e., that responds to the keep-alive).
Protocol
protocol
[HTTPProxyHost_Protocol]
Defines the protocol type.
 [0] HTTP (default)
 [1] HTTPS
HTTP Port
http-port
[HTTPProxyHost_Port]
Defines the port of the managed equipment.
The default is 0.
Note: The parameter is mandatory.
Security
TLS Context
tls-context
[HTTPProxyHost_TLSContext]
Assigns a TLS Context for the TLS connection with the HTTP
Proxy host.
By default, the default TLS Context (Index 0) is assigned.
To configure TLS Contexts, see ''Configuring TLS Certificate
Contexts'' on page 103.
Note: The parameter is applicable only if the connection
protocol is HTTPS (defined using the 'Protocol' parameter,
above).
Verify Certificate
verify-cert
[HTTPProxyHost_VerifyCert]
Enables TLS certificate verification when the connection with
the host is based on HTTPS.
 [0] No = No certificate verification is done.
 [1] Yes = (Default) The device verifies the authentication of
the certificate received from the HTTPS peer. The device
authenticates the certificate against the trusted root
certificate store associated with the associated TLS Context
(see 'TLS Context' parameter above) and if ok, allows
communication with the HTTPS peer. If authentication fails,
the device denies com
munication (i.e., handshake fails). The
device can also authenticate the certificate by querying with
an Online Certificate Status Protocol (OCSP) server whether
the certificate has been revoked. This is also configured for
the associated TLS Context.
Note: The parameter is applicable only if the connection
protocol is HTTPS (defined using the 'Protocol' parameter,
above).
15.6.4 Configuring an HTTP-based EMS Service
The EMS Services table lets you configure a single HTTP-based EMS service. For more
information on the EMS service, see ''HTTP-based Proxy Services'' on page 272.
The following procedure describes how to configure an EMS Service through the Web
interface. You can also configure it through ini file (EMSService) or CLI (configure network
> http-proxy ems-serv).
 To configure an EMS Service:
1. Open the EMS Services table (Setup menu > IP Network tab > HTTP Proxy folder >
EMS Services).
To Next Page
Loading...
Need help?
General
