AudioCodes MSBG Series User Manual

User's Manual 366 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
''Configuration Parameters Reference'' on page 927. To configure Proxy servers (Proxy
Sets), see ''Configuring Proxy Sets'' on page 346.
Note: To view the registration status of endpoints with a SIP Registrar/Proxy server,
see ''Viewing Registration Status'' on page 825.
 To configure the Proxy and registration parameters:
1. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
2. Configure the parameters as required.
3. Click Apply.
 To register or un-register the device to a Proxy/Registrar:
 Click the Register button to register.
 Click Un-Register button to un-register.
Instead of registering the entire device, you can register specific entities as listed below by
using the Register button located on the page in which these entities are configured:
 FXS/FXO endpoints, BRI endpoints, Trunk Groups - Trunk Group table (see
Configuring Trunk Groups on page
465)
 Accounts - Accounts table (see ''Configuring Registration Accounts'' on page 361)
18.2.1 SIP Message Authentication Example
The device supports basic and digest (MD5) authentication types, according to SIP RFC
3261. A proxy server might require authentication before forwarding an INVITE message. A
Registrar/Proxy server may also require authentication for client registration. A proxy
replies to an unauthenticated INVITE with a 407 Proxy Authorization Required response,
containing a Proxy-Authenticate header with the form of the challenge. After sending an
ACK for the 407, the user agent can then re-send the INVITE with a Proxy-Authorization
header containing the credentials.
User agents, Redirect or Registrar servers typically use the SIP 401 Unauthorized
response to challenge authentication containing a WWW-Authenticate header, and expect
the re-INVITE to contain an Authorization header.
The following example shows the Digest Authentication procedure, including computation
of user agent credentials:
1. The REGISTER request is sent to a Registrar/Proxy server for registration:
REGISTER sip:10.2.2.222 SIP/2.0
Via: SIP/2.0/UDP 10.1.1.200
From: <sip: 122@10.1.1.200>;tag=1c17940
To: <sip: 122@10.1.1.200>
Call-ID: 634293194@10.1.1.200
User-Agent: Sip-Gateway/Medaint 1000B Gateway and
SBC/v.7.20A.000.038
CSeq: 1 REGISTER
Contact: sip:122@10.1.1.200:
Expires:3600
2. Upon receipt of this request, the Registrar/Proxy returns a 401 Unauthorized
response:

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English