User's Manual 1070 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
62.10.5.10 Call Cut-Through Parameters
The call cut-through parameters are described in the table below.
Table 62-51: Call Cut-Through Parameters
Parameter Description
Enable Calls Cut
Through
configure voip > sip-
definition settings >
calls-cut-through
[CutThrough]
Global parameter enabling FXS endpoints to receive incoming IP calls
while the port is in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_IP2TelCutThroughCallBehavior). For a detailed
description of the parameter and for configuring the functionality in the Tel
Profiles table, see Configuring Tel Profiles on page 428.
Note:
 The parameter is applicable only to FXS interfaces.
 If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
cut-through-anable
[DigitalCutThrough]
Global parameter enabling PSTN CAS channels/endpoints to receive
incoming IP calls even if the B-channels are in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_DigitalCutThrough). For a detailed description of the
parameter and for configuring the functionality in the Tel Profiles table, see
Configuring Tel Profiles on page 428.
Note: If the functionality is configured for a specific Tel Profile, the settings
of the global parameter is ignored for calls associated with the Tel Profile.
62.10.5.11 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 62-52: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Automatic Dialing Table
configure voip >
gateway analog
automatic-dialing
[TargetOfChannel]
Defines telephone numbers that are automatically dialed when a specific
FXS or FXO port is off-hooked. The format of the ini file table parameter is
as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1,10;
Note:
 The first index of this table ini file parameter is 0.
 TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.
 TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.
To Next Page
Loading...
Need help?
General
