Version 7.2 39 Mediant 1000B Gateway & E-SBC
User's Manual 4. Configuring VoIP LAN Interface for OAMP
4 Configuring VoIP LAN Interface for OAMP
You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:
Embedded HTTP/S-based Web server - see ''Web Interface'' on page 39
Embedded command line interface (CLI) - see ''CLI'' on page 41
4.1 Web Interface
The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.
To configure the VoIP-LAN IP Address for OAMP through Web interface:
1. Connect one of the Ethernet ports located on the CRMX module directly to the
network interface of your computer, using a straight-through Ethernet cable.
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the
default IP address of the device; the Web interface's Web Login screen appears:
Figure 4-1: Web Login Screen
To Next Page
Loading...
Need help?
General
