User's Manual 914 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
To configure basic call testing:
1. Open the Test Call Settings page (Troubleshooting tab > Troubleshooting menu >
Test Call folder > Test Call Settings).
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint:
Figure 59-5: Configuring Basic Test Calls
3. Click Apply.
Note:
• The Basic Test Call feature tests incoming calls only and is initiated only upon
receipt of incoming calls with the configured prefix.
• For a full description of the parameter, see ''SIP Test Call Parameters'' on page
954.
• The test call is done on all SIP Interfaces.
• The test call is applicable only to the Gateway application.
59.7 Configuring SBC Test Call with External Proxy
The SBC Test Call feature tests incoming SBC SIP call flow between a simulated test
endpoint on the device and a remote SIP endpoint, when registration and routing is done
through an external proxy/registrar server such as a hosted IP PBX in the WAN. In other
words, the complete SIP flow, including the path to/from the external proxy/registrar can be
tested.
Note:
• The SBC Test Call feature is initiated only upon receipt of incoming calls and with
the configured prefix.
• This call test is done on all SIP interfaces.
As this test call type involves an SBC call, you need to configure regular SBC rules such as
classification and IP-to-IP routing. Therefore, this test call also allows you to verify correct
SBC configuration.
For this test call, you also need to configure the following call IDs:
Test Call ID - prefix number of the simulated endpoint on the device.
SBC Test ID - prefix number of called number for identifying incoming call as SBC test
call. The device removes this prefix, enabling it to route the call according to the IP-to-
IP Routing rules to the external proxy/registrar, instead of directly to the simulated
endpoint. Only when the device receives the call from the proxy/registrar, does it route
the call to the simulated endpoint.