Version 7.2 889 Mediant 1000B Gateway & E-SBC
User's Manual 55. Syslog and Debug Recording
Message Item Description
Message Body
Describes the message.
Timestamp
When the Network Time Protocol (NTP) is enabled, a
timestamp string [hour:minutes:seconds] is added to all
Syslog messages.
55.2.1.1 Event Representation in Syslog Messages
The Syslog message events that the device sends are denoted by unique abbreviations.
The following example shows an abbreviated event in a Syslog message indicating packet
loss (PL):
Apr 4 12:00:12 172.30.1.14 PL:5 [Code:3a002] [CID:3294] [Time:
20:17:00]
The table below lists the unique event abbreviations:
Table 55-4: Syslog Error Name Descriptions
Error Abbreviation Error Name Description
AA
Invalid Accumulated Packets Counter
AC
Invalid Channel ID
AL
Invalid Header Length
AO
Invalid Codec Type
AP
Unknown Aggregation Payload Type
AR
Invalid Routing Flag Received
AT
Simple Aggregation Packets Lost
CC
Command Checksum Error
CE
Invalid Cell Coder Code
CS
Command Sequence Error
ES
8 sec Timeout Before Disconnect
HO
Host Received Overrun
IA
Invalid AMR Payload
IC
Invalid CID Error
IG
Invalid G723 Code
IP
Invalid payload length
IR
Invalid RTCP Packet
IS
Invalid SID Length
LC
Transmitter Received Illegal Command
LF
Lost Fax Frames In High Speed Mode
LM
Lost Modem Frames In High Speed Mode
MI
Misalignment Error
To Next Page
Loading...
Need help?
General
