User's Manual 464 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
• TimeBetweenDigits: Defines the maximum time (in seconds) that the device waits
between digits received from the IP side. When the time expires, the device uses
the collected digits to dial the called destination number.
Note: For IP-to-Tel overlap dialing, to send ISDN Setup messages without including
the Sending Complete IE, you must configure the ISDNOutCallsBehavior parameter
to USER SENDING COMPLETE [2].
For more information on the above mentioned parameters, see ''PSTN Parameters'' on
page 1074. To configure ISDN overlap dialing using the Web interface, see ''Configuring
Trunk Settings'' on page 447.
21.8 Redirect Number and Calling Name (Display)
The following tables define the device's redirect number and calling name (Display) support
for various ISDN variants according to NT (Network Termination) / TE (Termination
Equipment) interface direction:
Table 21-2: Calling Name (Display)
NT/TE Interface DMS-100 NI-2 4/5ESS Euro ISDN QSIG
NT-to-TE
Yes Yes Yes Yes Yes
TE-to-NT
Yes Yes Yes No Yes
Table 21-3: Redirect Number
NT/TE Interface DMS-100 NI-2 4/5ESS Euro ISDN QSIG
NT-to-TE
Yes Yes Yes Yes Yes
TE-to-NT
Yes Yes Yes Yes* Yes
* When using ETSI DivertingLegInformation2 in a Facility IE (not Redirecting Number IE).
To Next Page
Loading...
Need help?
General
