AudioCodes MSBG Series User Manual

Version 7.2 967 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description

If you configure the parameter to Server & Client, you also
need to configure the SIPSRequireClientCertificate parameter
to Enable.
 For FQDN, the certificate may use wildcards (*) to replace
parts of the domain name.
TLS Client Verify Server
Certificate
configure network/security-
settings/tls-vrfy-srvr-cert
[VerifyServerCertificate]
Determines whether the device, when acting as a client for TLS
connections, verifies the Server certificate. The certificate is
verified with the Root CA information.
 [0] Disable (default)
 [1] Enable
Note: If Subject Name verification is necessary, the parameter
PeerHostNameVerificationMode must be used as well.
TLS Remote Subject Name
configure network/security-
settings/tls-rmt-subs-name
[TLSRemoteSubjectName]
Defines the Subject Name that is compared with the name
defined in the remote side certificate when establishing TLS
connections.
If the SubjectAltName of the received certificate is not equal to
any of the defined Proxies Host names/IP addresses and is not
marked as 'critical', the Common Name (CN) of the Subject field is
compared with this value. If not equal, the TLS connection is not
established. If the CN uses a domain name, the certificate can
also use wildcards (‘*’) to replace parts of the domain name.
The valid range is a string of up to 49 characters.
Note: The parameter is applicable only if the parameter
PeerHostNameVerificationMode is set to 1 or 2.
TLS Expiry Check Start
expiry-check-start
[TLSExpiryCheckStart]
Defines the number of days before the installed TLS server
certificate is to expire at which the device must send a trap
(acCertificateExpiryNotification) to notify of this.
The valid value is 0 to 3650. The default is 60.
TLS Expiry Check Period
expiry-check-period
[TLSExpiryCheckPeriod]
Defines the periodical interval (in days) for checking the TLS
server certificate expiry date.
The valid value is 1 to 3650. The default is 7.
62.4.5 SSH Parameters
Secure Shell (SSH) parameters are described in the table below.
Table 62-26: SSH Parameters
Parameter Description
Enable SSH Server
configure system > cli-settings
> ssh
[SSHServerEnable]
Enables the device's embedded SSH server.
 [0] Disable (default)
 [1] Enable
Server Port
configure system > cli-settings
> ssh-port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. The default port is 22.

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English