Version 7.2 943 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
For a detailed description of the table, see Configuring Underlying
Ethernet Devices on page 132.
62.2.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 62-10: IP Network Interfaces and VLAN Parameters
Parameter Description
IP Interfaces Table
IP Interfaces
configure network > interface
network-if
[InterfaceTable]
The table configures IP network interfaces.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes, InterfaceTable_InterfaceMode,
InterfaceTable_IPAddress, InterfaceTable_PrefixLength,
InterfaceTable_Gateway, InterfaceTable_VlanID,
InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of the table, see ''Configuring IP
Network Interfaces'' on page 135.
[EnableNTPasOAM] Defines the application type for Network Time Protocol (NTP)
services.
 [1] = OAMP (default)
 [0] = Control
Note: For the parameter to take effect, a device reset is required.
62.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 62-11: IP Network Routing Parameters
Parameter Description
Send ICMP Unreachable
Messages
configure network >
network-settings > icmp-
disable-unreachable
[DisableICMPUnreachable]
Enables sending of ICMP Unreachable messages.
 [0] Enable = (Default) Device sends these messages.
 [1] Disable = Device does not send these messages.
Send and Receive ICMP
Redirect Messages
Enables sending and receiving of ICMP Redirect messages.
 [0] Enable = (Default) Device sends and accepts these messages.
To Next Page
Loading...
Need help?
General
