AudioCodes MSBG Series User Manual

User's Manual 90 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
 To configure SNMP trap destinations:
1. Open the SNMP Trap Destinations table (Setup menu > Administration tab > SNMP
folder > SNMP Trap Destinations).
Figure 8-3: SNMP Trap Destinations Table
2. Configure the SNMP trap manager according to the table below.
3. Select the check boxes corresponding to the configured SNMP managers that you
want to enable.
4. Click Apply.
Note:
• Rows whose corresponding check boxes are cleared revert to default settings
when you click Apply.
• To enable the sending of the trap event,
acPerformanceMonitoringThresholdCrossing, which is sent every time a threshold
(high or low) of a performance monitored SNMP object is crossed, configure the
ini file parameter PM_EnableThresholdAlarms to 1.
• Instead of configuring SNMP trap managers with an IP address in dotted-decimal
notation, you can configure a single SNMP trap manager with an FQDN (see
''Configuring an SNMP Trap Destination with FQDN'' on page 91.
Table 8-2: SNMP Trap Destinations Table Parameters Description
Parameter Description
(check box)
[SNMPManagerIsUsed_x]
Enables the SNMP manager to receive traps and checks the
validity of the configured destination (IP address and port
number).
 [0] (check box cleared) = (Default) Disables SNMP
manager
 [1] (check box selected) = Enables SNMP manager
IP Address
[SNMPManagerTableIP_x]
Defines the IP address (in dotted-decimal notation, e.g.,
108.10.1.255) of the remote host used as the SNMP
manager. The device sends SNMP traps to this IP address.
Trap Port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP manager. The
device sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.
Trap User
[SNMPManagerTrapUser]
Associates a trap user with the trap destination. This
determines the trap format, authentication level, and
encryption level.
 v2cParams (default) = SNMPv2 user community string
 SNMPv3 user configured in ''Configuring SNMP V3
Users'' on page 92

AudioCodes MSBG Series Specifications

General

Brand	AudioCodes
Model	MSBG Series
Category	Gateway
Language	English