InteliCompact
NT
, SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
This output is active whenever the controller is in MAN mode.
This output is active whenever the controller is in AUT mode.
Binary output: Exerc Timer 1
This is an output from the Exercise timer 1. This output makes it easy to
make periodic tests of the gen-set and its activation depends on the
setpoints in the Date/time group.
Binary output: Exerc Timer 2
This is an output from the Exercise timer 2. Its behaviour depends on
setpoints in Date/time group.
Binary output: Power Switch
This is an output from the Power switch function.
Binary output: Neutral CB C/O
Neutral Circuit Breaker Close/Open output controls the generator Neutral
circuit breaker. It is intended for contactors – provides a continual active
signal if Neutral CB should be closed. See also setpoint #Neutral cont.
To Next Page
Loading...
Need help?
General
