EasyManuals Logo

Dell PowerVault MD3200i User Manual

Dell PowerVault MD3200i
282 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
Configuration: Disk Groups and Virtual Disks 115
NOTE: If you selected the Custom option, select your preferred dynamic
cache read prefetch setting (enabled/disabled) and segment size (8 KB to 512
KB).
2
Click
OK
.
Choosing an Appropriate Physical Disk Type
You can create disk groups and virtual disks in the storage array. You must
select the capacity that you want to allocate for the virtual disk from either
unconfigured capacity or free capacity available in the storage array. Then you
define basic and optional advanced parameters for the virtual disk.
With the advent of different physical disk technologies, it is now possible to
mix physical disks with different media types and different interface types
within a single storage array. In this release of MDSM, the following media
types are supported:
Hard physical disk
Solid State Disk (SSD)
Physical Disk Security with Self Encrypting Disk
Self encrypting disk (SED) technology prevents unauthorized access to the
data on a physical disk that is physically removed from the storage array. The
storage array has a security key. Self encrypting disks provide access to data
only through an array that has the correct security key.
The self encrypting disk or a security capable physical disk encrypts data
during writes and decrypts data during reads. For more information, see the
PowerVault Modular Disk Storage Manager online help topics.
You can create a secure disk group from security capable physical disks. When
you create a secure disk group from security capable physical disks, the
physical disks in that disk group become security enabled. When a security
capable physical disk is security enabled, the physical disk requires the correct
security key from a RAID controller module to read or write the data. All of
the physical disks and RAID controller modules in a storage array share the
same security key. The shared security key provides read and write access to
the physical disks, while the physical disk encryption key on each physical disk
is used to encrypt the data. A security capable physical disk works like any
other physical disk until it is security enabled.
book.book Page 115 Saturday, September 24, 2011 9:06 AM

Table of Contents

Other manuals for Dell PowerVault MD3200i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerVault MD3200i and is the answer not in the manual?

Dell PowerVault MD3200i Specifications

General IconGeneral
HDD speed15000 RPM
RAID levels0, 1, 5, 6, 10
Storage drive capacity600 GB
Storage drive interfaceSerial Attached SCSI (SAS)
Maximum supported storage capacity115.2 TB
Number of storage drives installed12
InterfaceRJ-45, SAS, PS/2
Connector(s)4x RJ-45, 1x 6Gb SAS, 1x PS/2
Power supply typeAC
Dimensions (WxDxH)446.3 x 561 x 86.8 mm
Power requirements90 - 264 V, 47 - 63 Hz
Networking featuresGigabit Ethernet
Compatible operating systemsWindows, Linux, VMware, Hyper-V
InternalNo
LED indicatorsHDD, Power, Power fail, Status
Operating temperature (T-T)10 - 35 °C
Operating relative humidity (H-H)20 - 80 %
Power consumption (typical)25 W
Power supply unit (PSU) capacity600 W
Weight and Dimensions IconWeight and Dimensions
Weight29300 g

Related product manuals