Digi IX30 User Manual

Digi IX30 Quick start
Step 1: Connect your device
1. Insert your activated SIM (2FF) card(s) provided by your cellular carrier into the device:
a. Use a Philips #1 driver to remove the SIM slot cover.
b. For high-vibration environments, apply a thin layer of dielectric grease to the SIM contacts.
Note If the IX30 device is used in an environment with high vibration levels, SIM card
contact fretting may cause unexpected SIM card failures. To protect the SIM cards, Digi
strongly recommends that you apply a thin layer of dielectric grease to the SIM contacts
prior to installing the SIM cards. See Apply Dielectric Grease over SIMContacts for
instructions.
c. Insert the SIM card(s) into the SIM sockets. Insert the end of each SIM card with the
chamfered corner positioned as indicated. Push the SIM in until it clicks into place. SIM
slot one is the lower slot, SIMslot two is the upper slot.
IX30 User Guide
19

Digi IX30 Specifications

General

Brand	Digi
Model	IX30
Category	Network Router
Language	English