Command line interface Configuration mode
IX30 User Guide
998
n
You can also use a combination of both of these methods:
1. Change to the auth node:
(config)> auth
(config auth)>
2. Enter the revert command with the path set to method:
(config auth)> revert method
(config auth)>
3. Save the configuration and apply the change:
(config auth)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
Enter strings in configuration commands
For string parameters, if the string value contains a space, the value must be enclosed in quotation
marks. For example, to assign a descriptive name for the device using the system command, enter:
(config)> system description "Digi IX30"
Example: Create a new user by using the command line
In this example, you will use the IX30 command line to create a new user, provide a password for the
user, and assign the user to authentication groups.
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, create a new user with the username user1:
n
Method one: Create a user at the root of the config prompt:
(config)> add auth user user1
(config auth user user1)>
To Next Page
Loading...
Need help?
General
