Services Simple Network Management Protocol (SNMP)
IX30 User Guide
529
(config)> service snmp privacy_protocol AES
(config)>
12. (Optional) Enable read-only access to to SNMP version 2c.
(config)> service snmp enable 2c true
(config)>
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Download MIBs
This procedure is available from the WebUI only.
Required configuration items
n
Enable SNMP.
To download a .zip archive of the SNMP MIBs supported by this device:
Web
1. Log into the IX30 WebUI as a user with Admin access.
2. Enable SNMP.
See Configure Simple Network Management Protocol (SNMP) for information about enabling
and configuring SNMP support on the IX30 device.
3. On the main menu, click Status. Under Services, click SNMP.
Note If you have recently enabled SNMP and the SNMP option is not visible, refresh your
browser.
The SNMP page is displayed.
To Next Page
Loading...
Need help?
General
