System administration Update system firmware
IX30 User Guide
851
Firmware update completed, reboot device
>
6. Reboot the device to run the new firmware image using the reboot command.
> reboot
Rebooting system
>
7. Once the device has rebooted, log into the IX30's command line as a user with Admin access
and verify the running firmware version by entering the show system command.
> show system
Hostname : IX30
FW Version : 22.11.48.10
MAC : 0040FF800120
Model : Digi IX30
Current Time : Thurs, 24 November 2022 19:48:00 +0000
Uptime : 42 seconds (42s)
>
Dual boot behavior
By default, the IX30 device stores two copies of firmware in two flash memory banks:
n
The current firmware version that is used to boot the device.
n
A copy of the firmware that was in use prior to your most recent firmware update.
When the device reboots, it will attempt to use the current firmware version. If the current firmware
version fails to load after three consecutive attempts, it is marked as invalid and the device will use
the previous firmware version stored in the alternate memory bank.
If the device consistently loses power during the boot process, this may result in the current firmware
being marked as invalid and the device downgrading to a previous version of the firmware. As a result
of this behavior, you can use the following procedure to guarantee that the same firmware is stored in
both memory banks:
Web
To Next Page
Loading...
Need help?
General
