11. HOW TO MONITOR ROUTES
11-12
To close the [Instant Track] dialog box, click the [Close] button. (The system continues
monitoring the instant track route.)
The following occurs when sensor data is lost while using the instant track function.
Note: If there is no original route (safe off-track mode only) or the original route is not
checked, the message "Not checked against ENC chart" appears in the permanent
warning box.
How to stop monitoring an instant track route
Click the [Stop] button on the [Monitoring] page in the [Instant Track] dialog box to stop
monitoring the instant track route. The system returns to monitoring the monitored
route and the [Planning] page of the [Instant Track] dialog box opens.
For the [Back to Track] mode, the instant track mode is canceled when the vessel re-
turns to the monitored route. The instant track is greyed out to show that it is inactive.
Monitoring condition Result
Instant track route monitor-
ing.
• An instant track route under creation is deleted. No
route can be created.
• The [Stop] button is pushed or the instant track route
is followed until its completion.
• After the instant track route is completed, an error
message appears and the [Instant Track] dialog box
closes.
No monitored route An instant track route under creation is deleted.
Monitored route active After the route is completed, an error message appears
and the [Instant Track] dialog box closes.
To Next Page
Loading...
Need help?
General
