22-1
22. CONNING DISPLAYS
22.1 Main Conning Display
The main conning display provides relevant sensor information data (including engine
data) from external equipment, on one display to facilitate safe and efficient monitor-
ing. The ECDIS accepts sensor information data in analog, serial and contact signal
formats.
Six sets of conning displays are available, and they are arranged at installation. Con-
sult with the installer of the equipment to decide the content and layout of each display.
To show the conning display, click the Display mode button on the Status bar to select
[CONNING].
Note: Analog data is shown in the lowest value of the setting range when the data is
not input.
Note: The cursor can be moved be-
tween the main monitor and a sub
monitor and vice versa if the sub
monitor is configured to show the
Conning display. Push the scroll-
wheel until the cursor moves to the
other monitor.
Conning display Status bar (see next page)
CONNING
EE
Main monitorSub monitor
ECDIS
Cursor
Conning
Cursor
Push
scrollwheel
To Next Page
Loading...
Need help?
General
