Furuno FMD-3200 User Manual

24. MAINTENANCE AND TROUBLESHOOTING
24-5
ENC chart cannot be
displayed
• no ENC chart for area.
• dongle is not connected.
• Open ENC chart from [Manage
Charts] dialog box.
• Connect dongle.
past track is not
displayed
• past track is not selected to be vis-
ible.
• Open [Tracking] page of [Symbol
Display] menu and select [Own
Ship Past Tracks] to [CCRP], [Pri-
mary], [Secondary] or [Pivot] as
appropriate.
monitored user chart
is not displayed on
ECDIS display
• user chart is not selected to be vis-
ible.
• Open [Mariner] page of [Symbol
Display] menu and select parts to
show.
route monitoring is
stopped
• Alert 691: RM Stop - Exceed Max
XTE. Own ship is too far away
from the route.
• Alert 692: No Valid Sensor Data.
ECDIS internal error.
• Alert 693: RM Stop - Other
Causes. Required data (position,
SOG/COG) not found.
• Steer the ship back to the route
then restart route monitoring.
• Request service.
• Check sensor connections.
user chart is not dis-
played on radar
overlay
• user chart is not selected in Voy-
age navigation mode.
• Select user chart in Voyage navi-
gation mode.
message "Nearing
memory usage limit.
Click the Restart
button to restart the
system to prevent
trouble."
appears
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
• If you need to save your work, click
the [Later] button then reset the
power. If you don’t need to save
your work, click the [Restart] but-
ton.
Note that the notice does not ap-
pear in the Conning mode.
message "Nearing
memory usage limit.
If you will start moni-
toring, click the Re-
start button to restart
the system to pre-
vent trouble during
route monitoring."
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
• Click the [Restart] button.
message "Memory
usage limit reached.
Click the Restart
button to restart the
system to prevent
trouble."
appears.
• the memory usage limit for soft-
ware is reached. Performance
may be affected.
• Click the [Restart] button to reset
the power. No other operations are
available other than restart.
Note that the notice does not ap-
pear in the Conning mode.
some Display mode
buttons are yellow
• the memory usage limit for soft-
ware is close to capacity. Perfor-
mance may be affected.
• Stop all operations and reset the
power.
If… then… Remedy

Furuno FMD-3200 Specifications

General

Brand	Furuno
Model	FMD-3200
Category	Marine Equipment
Language	English