Garmin aera 660 Pilot’s Guide
190-02017-20 Rev. E
Appendix D
173
Overview Navigation Flight Planning Hazard Avoidance Additional Features Appendices Index
APPENDIX D: INSTALLATION AND INTERFACING
MOUNTING THE aera 660 IN THE AIRCRAFT
The aera 660 yoke mount comes fully assembled as shown below. The yoke mount is
designed to fit the majority of conventional aircraft yokes and center column controls.
aera Cradle
Clamp Adjustment Knob
WARNING: It is the sole responsibility of the owner/operator of the aera 660
to place this mount and secure the unit so that it will not interfere with the
aircraft's operating controls and safety devices, or cause damage or personal
injury in the event of an accident or turbulence. Do no mount the aera 660
where the pilot or passengers are likely to impact it in an accident, collision,
or turbulence. The mounting hardware provided by Garmin is not warranted
against turbulence, collision damage, or related consequences.
NOTE: After installation, verify flight controls are free and clear per the flight
manual of the applicable aircraft and that the aera 660 yoke mount and wiring
do not cause any interference with the flight controls.
To Next Page
Loading...
Need help?
General
