To Next Page

To Previous Page

2-22 F650 Digital Bay Controller GEK-106310AB

2.4 TECHNICAL SPECIFICATIONS 2 PRODUCT DESCRIPTION

2.4.3.6 DATA LOGGER

2.4.4 USER-PROGRAMMABLE ELEMENTS

2.4.4.1 PLC LOGIC

2.4.4.2 FLEXCURVES

2.4.4.3 USER-PROGRAMMABLE LEDS

Number of Channels:

1 to 16

Parameters Any available analog actual value

Samples 1 sec., 1, 5, 10, 15, 20, 30, 60 min.

Storage Capacity Fixed, 32768 measures

Programming language: The logical configuration is performed using graphical functions based on the

IEC 61131-3 standard.

Lines of code: 512

Supported operations: NOT, XOR, OR (2 to 8 inputs), AND (2 to 8 inputs), NOR (2 to 8 inputs),

NAND (2 to 8 inputs), Latch (Reset Dominant), Edge Detectors, Timers.

2 inputs default gates, from 3 to 8 inputs provided in library format.

Libraries: Logical gates fully programmable by user. To create user-programmable logic to

be distributed as a single object.

Inputs: Any logical variable, contact or virtual input

Number of timers: 8 maximum in each logic scheme (provided in library format)

Number: 4 (A through D)

Reset points: 40 (0 through 1 of pickup)

Operate points: 80 (1 through 20 of pickup)

Time delay: 0 to 65535 ms in steps of 1

Saturation Level 20 times the pickup level

Number: 15 configurable LEDs plus a ready non configurable LED

Programmability: from any logical variable, contact, or virtual input

Reset mode: Self-reset or Latched.

The first 5 LED’s are latched by hardware (red color ones), usually configured for

trip signals.

The following 10 ones (yellow and green) are self-reset but can be latched

through PLC configuration.

Reset Signal:

The LED’s can be reset by hardware, pressing the front “esc” key during more

than 3 seconds or using the LED reset signal through PLC configuration.

GE F650 User Manual

Other manuals for GE F650