● Warning Messages 6-51
001
Transmission
code error
¡The transmitted code was not defined
for communication use.
¡The transmitted message had an illegal
structure.
Check the baud rate
and transmission code.
002
Print
specifications
code error
The print specifications data value was
illegal.
Check the print
specifications
communication text.
003
Print character
code error
The maximum value was exceeded by the
number of characters for printings that
could be received as one item.
Check the printings
communication text.
004
Item number
error
The item number code value was illegal.
Check the printings
communication text.
005 Header error The header value was illegal. Check the header.
006
Ready-for-
reception error
¡An attempt was made to establish
communication while the "not ready for
reception" state prevailed.
¡"Apply" key and message window were
both displayed.
¡"Off-line fixed" has been set in
Communication environment.
¡Communication monitor screen was
displayed.
Check the transmission
timing.
008
Print
specifications
code error
The maximum value was exceeded by the
print specifications data.
Check the print
specifications
communication text.
009 ETX code error The ETX code position was illegal.
Check the transmission
procedure and ETX code.
010 DLE code error The DLE code position was illegal.
Check the transmission
procedure and DLE code.
011 STX code error The STX code position was illegal.
Check the transmission
procedure and STX code.
6.7 Warning Messages
¡
If any communication is in error, the associated warning message appears below
the status display area.
¡
Note the message to confirm the error and then take remedial action as
appropriate for the indicated error code.
To Next Page
Loading...
Need help?
General
