Hitachi PXR-D User Manual

● On-screen Message Descriptions 8-3
The high-voltage power
supply output voltage is
too low or too high.
10
¡ Contact your nearest local
distributor.
Deflection Voltage
Fault
5
The ink drops are poorly
charged, with too low
charge.
¡ Clean the gutter, deflection
electrode, and its
surroundings.
¡ Adjust the excitation setting
to make sure that the ink
drops are well made.
¡ Adjust ink pressure.
Ink Drop Charge
Too Low
6
7
The engine section
malfunctioned due to
noise.
¡Turn the power OFF and
then back ON.
Noise Fault M
8
The engine section
malfunctioned due to
noise.
¡Turn the power OFF and
then back ON.
Noise Fault S
9
The deflection electrode
voltage is too low.
¡ Dry the deflection electrode
and its surroundings.
Deflection Voltage
Leakage
4
The automatic
replenishment sequence
is taking too much time.
¡ Contact your nearest local
distributor.
Replenishment
Time-out
3
The makeup ink level in
the makeup ink reservoir
is too low
(if replenishment is not
effected within 60
minutes after warning
output)
¡ Add the makeup ink to the
makeup ink reservoir.
Makeup Ink Low
Fault
The ink drops are not
electrically charged.
¡ Check if the ink stream is at
about the center of the
gutter.
¡ Clean the gutter, deflection
electrode, and its
surroundings.
¡ Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
¡ Check the ink pressure.
No Ink Drop
Charge
＊：After cleaning, wipe
off the makeup ink
well from the surface
of each component
with a piece of
wiping paper. Then,
dry the surfaces.
No.
Message
The ink level in the ink
reservoir is too low. (If
the ink is not added or
replaced within 60
minutes after warning
output, the printer comes
to a stop with the
warning condition
replaced by a fault
condition.)
1
2
¡ Add ink to the ink reservoir.
Ink Low Fault
(1) Faults that invoke ink stoppage
8.2 On-screen Message Descriptions
8.2.1 Fault messages
Meaning of message Remedy
The ink level in the main
ink tank is unduly high.
¡ Drain the ink from main ink
tank drain tube.
( page 7-45).
¡ In addition, to ensure normal
ink density, perform "Ink
replacement".
Main Ink Tank Too
Full

Hitachi PXR-D Specifications

General

Brand	Hitachi
Model	PXR-D
Category	Printer
Language	English