7-1 ● Circulation System Operating and Adjustment Procedures
¡
Never drain the ink or makeup ink waste solution into public sewer systems.
Waste disposal must comply with all appropriate regulations.Consult the
appropriate regulatory agency for further imformation.
¡
Exercise care not to inadvertently disconnect, forcibly pull, or bend a piping tube.
Since the ink and makeup ink in some portions of piping tubes are pressurized,
they may splash and enter your eyes or mouth or soil your hands or clothing.
If the ink or makeup ink, enters your eyes or mouth, immediately flush with warm
or cold water and see a physician.
¡
When charging a refill of ink or makeup ink, exchanging ink, or otherwise
handling ink or makeup ink, take enough care not to spill ink or makeup ink. If you
spill any ink or makeup ink by mistake, wipe it off neatly and promptly with wiping
paper or something similar. Do not close the maintenance cover until you make
sure that the portion you have just wiped is completely dry.
You must pay particular attention when you have spilled ink or makeup ink inside
the printer and it is not completely dry. Why? Because vapors of ink or makeup
ink will stay inside the printer and may catch on or cause a fire.
If you find it hard to wipe the printer when energized, stop it with the maintenance
cover open. Power it down, then wipe it off again.
¡
Should you find a leak of ink or makeup ink inside the printer while the printer is
running or being maintained, wipe it off promptly with wiping paper or something
similar. Then, with the maintenance cover open, stop the printer, power it down,
and repair the leak.
A continued run with a leak of ink or makeup ink will cause an anomaly, resulting
in abnormal printing.
Ink and makeup ink are flammable. They may therefore catch on or cause a fire.
¡
If you wish to receive ink drops in a beaker, for a printing test for example, use an
electrically conductive beaker and connect the beaker securely to the ground.
Do not let the tip of the printing head enter the beaker.
Ink drops used for printing are electrically charged. An ungrounded beaker has a
gradually rising charge, possibly catching on or causing a fire.
WARNING
¡
When handling the ink or makeup ink, which contatins organic solvent, observe
the following precautions.
Wear protective gloves and safety goggles to avoid direct skin contact.
If skin is contacted, thoroughly clean it with soap and warm or cold water.
When transferring the ink or makeup ink to or from a bottle, exercise care not
to let it come into contact with the printer or surrounding articles. If anything is
contacted, wipe it clean with a cloth moistened with ethyl alcohol.
Notice that there is a possibility that a cap and a content may fly with inner
pressure when opening the container of ink and a solvent.
Please open a cap of container an even place.
CAUTION
7. Circulation System Operating
and Adjustment Procedures
3
2
1
4
To Next Page
Loading...
Need help?
General
