¡
Ink and makeup ink must be stored as flammable liquids. Storage
must comply with local regulatory requirements. Consult the
appropriate regulatory agency for further information.
¡
If extraneous noise enters the printer, it may malfunction or break
down.
For maximum noise immunity, observe the following installation and wiring
precautions.
Ensure that 100 to 120 VAC or 200 to 240 VAC power cables are not
bundled with other power supply cables.
Insulate the printer main body and print head so that they do not come
into direct contact with the conveyor or other devices.
If the employed print target detector is housed in a metal case, use a
plastic mounting brace for the purpose of insulating the detector from the
conveyor and other devices.
Be sure that the print target detector wiring is not bundled together with
other power supply cables.
Safety Precautions
(Continued)
CAUTION
¡
Ensure that all electrical wiring, connections and grounding comply
with applicable codes. Properly connect the printer to its dedicated
ground.
Complete the above procedure to avoid electrical shock hazards.
3
2
1
4
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
（
）
To Next Page
Loading...
Need help?
General
