Page Segment Command Set
Note: Because page segments use more than the normal amount of printer
storage, use page segments only when data needs to be kept.
Include Page Segment (IPS)
Length D67F Flag Correlation ID (Optional) DATA
The Include Page Segment command causes a previously stored set of
commands to process in the input data stream as though they were just received
from the host. The printer places the segment at the current presentation
position and updates the presentation position as a result of this command.
The DATA field is two bytes in length and can be any value between X
'01' and
X
'7F '. This value is the page segment identifier, and it specifies the page
segment to include. A value specifying a page segment identifier that is not
defined in the printer causes an exception to occur.
Delete Page Segment (DPS)
Length D66F Flag Correlation ID (Optional) DATA
The Delete Page Segment command deletes (clears) either a single page
segment or all page segments from the printer memory.
The DATA field is two bytes in length and can be any value between X
'00' and
X
'7F '. This value is the page segment identifier, and it specifies the page
segment to delete. A value of zero deletes all segments.
Delete Font (DF)
Length D64F Flag Correlation ID (Optional) DATA
The Delete Font command provides a means for the control unit to delete one or
more fonts from the printer. The DATA field contains the following information:
Table 107. Data Field-Delete Font Command
Byte Value Description
0
11
1E
1F
Deletion Type
Delete the Single Byte Font Specified in Bytes 1-2
Delete All Fonts
Delete All Fonts
1-2 0001-7EFF Loaded Font Identifier (Ignored if Deletion Type Equals 1E or
1F)
3 00 Reserved
4-5 0000 Reserved
Chapter 3. IPDS Commands Reference 133
To Next Page
Loading...
Need help?
General