Installation and Configuration
Attaching to LU1-IPDS-Remote SNA 3174 Control Unit
LU1-IPDS mode is utilized when PSF is not needed to to accomplish the print
function desired but IPDS is. (The optional IPDS feature is required to use this
function.) An existing remote 3174 SNA-connected control unit is assumed. The
steps required to install an LU1-IPDS printer for host definitions are as follows:
1. Define to NCP point to LU1 default logmode entry defined below
2. Define to VTAM by adding logmode entry to VTAM Logmode Table
3. Define to JES2 (May not required if VPS. See details below)
4. Define to JES328X Print Facility, VPS, or equivalent
5. Select the options on the printer that are appropriate for the environment.
Step 1 - NCP Definition
MYPRINT Group ...
Line ...
Service ...
REMPU74 PU ...
REM6400 LU LOCADDR=#, (# replaced by port on control unit)
DLOGMOD=6400IPDR, (Default LOGMODE ENTRY NAME)
MODETAB=MYTABLE (Table name containing MODEENT)
Step 2 - VTAM Definition
The following entry should be placed in the VTAM MODE TABLE specified
above or another of your choice.
6400IPDR MODEENT LOGMODE=6400IPDR,
FMPROF=X'03',TSPROF=X'03',PRIPROT=X'B1',
SECPROT=X'90',COMPROT=X'7080',RUSIZES=X'87C6',
PSERVIC=X'01000000E100000000000000'
PSNDPAC=X'01',SRCVPAC=X'01'
Step 3 - JES2 Definition
This definition is not required if you are using VPS and using
U1 - U9999 as the printer ID.
RMT1 LUTYPE1,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCMPCT,
SETUPHDR,CONSOLE (SETUPHDR=PDIR JES2 V3)
R1.PR1 CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,T/C,P),
CKPTPAGE=30
DESTID NAME=P6400,DEST=R1
Step 4 - JES328X Print Facility or VPS Definition
An application program must provide the IPDS datastream to control the printer.
GDDM, VPS, and other applications support IPDS as well as numerous
application programs, both customer written and vendor supplied. Refer to the
vendor documentation for defining an IPDS printer to that program. If specific
reference is not made to the 6400 you may use an IBM 4234 definition.
Step 5 - Printer Settings
It is recommended that the following fastest default printer settings be used:
•
Printer Control => Interface Selection => Coax
•
Coax Interface => CT0 Format Control => Standard
•
Emulation Configuration => IPDS
•
Emulation Configuration => IPDS => Override Hosts => *Disable
Chapter 2. System Configuration 15
To Next Page
Loading...
Need help?
General